TM 5-3805-262-20
6-2. DRIVE SHAFTS MAINTENANCE (CONT)
b. Center Drive S h a f t a nd
Support Bea r i ng
(cont) .
(2) Replacement (cont).
INSTALLATION (SHEET 1 OF 2)
SUPPORT BEARING
(a) Position support bearing (10) on front drive shaft.
(b) Install four capscrews (7), lock washers (9), and nuts (8). Tighten nuts
(8) to 100-200 lb-ft.
(c) Tighten two setscrews in support bearing (page 6-37).
( d ) P e r f o r m s t e p s ( e ) t h r o u g h ( i ) o f f r o n t d r i v e s h a f t i n s t a l l a t i o n ( p a ge
6-37) above.
( e ) P o s i t i o n c e n t e r d r i v e s h a f t ( 5 ) u n i v e r s a l j o i n t o n f r o n t d r i v e s h a f t
yoke; secure using four capscrews (1) and lock washers (2). Tighten
capscrews to 63-83 lb-ft.
( f ) T i g h t e n c a p o n c e n t e r d r i v e s h a f t ( 5 ) .
6-42
