TM 5-3805-262-20
INSTALLATION (SHEET 2 OF 2)
CENTER DRIVE SHAFT
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t ed
a r e a . A v o i d c o n t a c t w i t h s k i n , e y e s a n d c l o t h e s a n d d o n ' t b r e a t he
vapors. Do not use near open flame or excessive heat and don't smoke
w h e n u s i n g i t . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y . I f y o u
b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c al
a t t e n t i o n i m m e d i a t e l y . I f c o n t a c t w i t h s k i n o r c l o t h e s i s m a d e , f l u sh
w i t h l a r g e a m o u n t s o f w a t e r .
If contact with eyes is made, wash eyes
with water and get medical aid immediately.
( a)
(b)
( c)
(d)
( e)
( f )
Using clean cloth moistened with cleaning solvent P-D-680, clean center
drive shaft (5) universal joints mounting surface and mating surface on
front drive shaft and transmission yokes .
Loosen cap on center drive shaft (5) and push ends of center drive shaft
t o g e t h e r .
Position center drive shaft (5) tube end (tube end: end on which cap
screws onto) universal joint on transmission yoke and install four lock
washers (4) and capscrews (3).
Tighten capscrews to 63-83 lb-ft .
Extend center drive shaft (5) by pulling shaft out from tube end. Then,
position universal joint mounted on shaft end of drive shaft (5) on
front drive shaft yoke and install four lock washers (2) and capscrews
(1). Tighten capscrews to 63-83 lb-ft.
Tighten cap on center drive shaft (5).
Service center drive shaft (page 6-38).
B e s u r e t r a n s p o r t / s e r v i c e l i n k i s d i s e n g a g e d b e f o r e d r i v i n g v e h i c l e .
F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y o r d e a t h d u e t o l o s s of
s t e e r i n g c o n t r o l .
6-43
