TM 5-3805-262-20
7-2. SERVICE BRAKE SYSTEM MAINTENANCE (CONT)
d. H o s e s , L i n e s, a n d F i t t i n g s ( c o n t ) .
(3) Rear Brakes Hoses, Lines, and Fittings (cent).
REMOVAL (SHEET 2 OF 2)
(e) At other end of hose (4), loosen clamp (3) and disconnect hose from el-
bow (5) at top of brake actuator. Do this by firmly grasping hose and
pulling from elbow. Remove clamp and hose from loader.
(f) Loosen and remove fitting (7), gasket (8), adapter (9), and gasket (10).
Discard gaskets (8 and 10). Remove adapter (9) from hose fitting (11).
( g ) A t c e n t e r o f r e a r a x l e , loosen and disconnect hose fitting (6) from tee
(30). Remove hose (12) from loader.
(h) At either left or right axle end, at axle mounting hardware, loosen and
remove nut (13), lock washer (14), capscrew (15), and spacer (16).
(i) Spread clamp (17) and remove from tube (25). Spread clamp (18) and re-
move from axle mounting capscrew.
( j ) A t e i t h e r l e f t o r r i g h t b r a k e c a l i p e r ,
loosen and disconnect tube fit -
ting (19) from adapter (22).
(k) Loosen and remove fitting (20), gasket (21), adapter (22), and 0-ring
(23). Discard gasket and 0-ring .
(l) Loosen and disconnect tube fitting (24) and remove tube (25) from load-
e r .
NOTE
Repeat steps (h) through (1) above to disconnect and remove remaining
tube (26) from loader.
(m) At top center of axle housing, remove nut (27), lock washer (28), and
capscrew (29). Remove tee (30).
(n) If necessary, remove differential assembly mounting nut (31) and washer
(32) and remove bracket (33).
7-44
