TM 5-3805-262-20
INSTALLATION (SHEET 1 OF 2)
(a) If removed, put bracket (33) on axle housing stud and secure using wash-
er (32) and nut (31). Tighten nut securely.
(b) Position tee (30) on bracket (33). Install capscrew (29), lock washer
(28), and nut (27). Tighten nut securely.
(c) Put new gasket (21), adapter (22), and new 0-ring (23) on fitting (20).
( d ) A t e i t h e r l e f t o r r i g h t b r a k e c a l i p e r , i n s t a l l f i t t i n g ( 2 0 ) , g a s k et
(21), adapter (22) and 0-ring (23) in brake caliper port. Don’t tighten
f i t t i n g y e t.
(e) Put tube (26 or 25) in position between tee (30) and adapter (22). Con-
n e c t a n d t i g h t e n t u b e f i t t i n g ( 2 4 ) t o t e e.
( f ) C o n n e c t a n d t i g h t e n t u b e f i t t i n g ( 1 9 ) t o a d a p t e r ( 2 2 ) . T i g h t e n f i t t i ng
(20) securely.
(g) Spread clamp (18) and install on axle mounting capscrew.
(h) Spread clamp (17) and install on tube (26 or 25).
( i ) I n s t a l l c a p s c r e w ( 1 5 ) , s p a c e r ( 1 6 ),
lock washer (14), and nut (13) to
secure clamps (17 and 18) and, in turn, tube (26 or 25). Tighten nut se-
c u r e l y.
NOTE
Repeat steps (c) through (i) above to install remaining tube (26 or 25)
to brake caliper on remaining axle end if necessary.
( j ) I n s t a l l a d a p t e r ( 9 ) o n h o s e f i t t i n g ( 1 1 ) . P u t n e w g a s k e t ( 8 ) , a d a p t e r
(9), and new gasket (10) on fitting (7). Install these parts in port at
r e a r o f b r a k e a c t u a t o r . D o n ’ t t i g h t e n f i t t i n g y e t.
(k) Route hose (12) over to tee (30). Connect and tighten hose fitting (6)
t o t e e ( 3 0 ) . T i g h t e n f i t t i n g ( 7 ) s e c u r e l y.
(l) Install elbow (5) in brake actuator and elbow (2) in brake hydraulic
reservoir. Tighten elbows securely.
(m) Put clamps (1 and 3) on hose (4).
(n) Connect hose (4) to elbows (2 and 5). Do this by firmly pushing hose on-
to elbows.
(o) Position clamps (1 and 3) at ends of hose (4). Tighten clamps to secure
hose.
7-49
