TM 5-3805-262-20
7-3. AIR BRAKE SYSTEM MAINTENANCE (CONT)
h. Air Compressor Lines (cont).
(2) Replacement (cont).
INSTALLATION (SHEET 5 OF 5)
(q)
( r )
( s )
( t )
(u)
(v)
(w)
(x)
I f r e m o v e d , i n s t a l l
tee and safety valve
i n a i r r e s e r v o i r p o r t.
Connect and tighten air
hose (4) to governor (5)
and to tee located at top
o f a i r r e s e r v o i r.
If removed, install tee (2)
in
engine cylinder block. Connect
tube (3) to tee and tighten
tube nut securely.
Connect oil supply hose (1) to
tee (2) and tighten hose fit-
t i n g s e c u r e l y .
Connect oil supply hose (1) to air compressor and tighten.
Connect alcohol evaporator lines and fittings to air compressor (page
7-122).
Close drain valve located on bottom of air reservoir.
Adjust air compressor drive belt tension (page 7-96) and reinstall
engine right side panels (page 9-17).
Start and operate engine at idle speed until AIR PRESS gage needle
located on left instrument cluster indicates in green area then turn off
(y)
engine.
7-116