TM 5-3805-262-20
INSPECTION (SHEET 2 OF 2)
(6) Inspect body (33) for cracks, breaks, dents, or other damage. Replace if
n e c e s s a r y.
( 7 ) I n s p e c t r e m a i n i n g p a r t s f o r s t r i p p e d o r c r o s s e d t h r e a d s , d e f o r m a t i o n,
cracks, or breaks, Replace defective parts.
REASSEMBLY
(1)
(2)
(3)
If expansion plug (32) was removed, install
new expansion plug using a hammer and 3/8
inch point drive pin punch.
I n s t a l l f i l t e r ( 3 1 ) a n d s e c u r e w i t h r e t a i n i ng
r i n g ( 3 0 ) .
Put seal ring (29) on tube (28). Install tube
(28) and seal ring (29) in body (33). Tighten
tube (28) securely .
W h e n p e r f o r m i n g f o l l o w i n g s t e p , b e c a r e f ul
n o t t o o v e r t i g h t e n v i s e .
T o d o s o w i ll
distort and damage cap (24).
(4)
(5)
(6)
(7)
(8)
( 9)
Put cap (24) in vise. Don’t overtighten vise.
Put grommet (25) on large diameter shoulder
of check valve (26).
Install grommet (25) and check valve (26) in
cap (24) with grommet facing downward.
Install valve spring (27) on check valve
( 2 6 ).
Install valve housing (23) on cap (24) and
t i g h t e n s e c u r e l y.
Remove cap (24) with assembled parts from
v i s e .
(10) Install valve housing (23) and assembled
parts (24 through 27) in body (33). Tighten
valve housing securely.
(11) Install plug (22) in body (33) and tighten
s e c u r e l y.
(12) Put gasket (21) on top of jar (20) and
install jar on body (33).
7-121
