TM 5-3805-262-20
REMOVAL
(1)
(2)
(3)
( 4)
( 5)
(6)
Remove three nuts (1), lock washers (2), washers (3), capscrews (4), and
washers (5).
Remove two nuts (6), lock washers (7), washers (8), capscrews (9), wash-
ers (10), sleeves (11), and washers (12).
Support engine hood (17) and remove three nuts (13), lock washers (14),
capscrews (15), and washers (16). Remove engine hood (17).
Remove two nuts (18), lock washers (19), and capscrews (20).
Remove side support (21).
Repeat steps
side support
CLEANING AND INSPECTION
(1) through (5) above for remaining engine hood (17) and
( 2 1 ).
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t ed
a r e a . A v o i d c o n t a c t w i t h s k i n,
e y e s a n d c l o t h e s a n d d o n ’ t b r e a t h e
v a p o r s .
Do not use near open flame or excessive heat and don’t smoke
w h e n u s i n g i t . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y . I f y ou
b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c al
a t t e n t i o n i m m e d i a t e l y . I f c o n t a c t w i t h s k i n o r c l o t h e s i s m a d e , f l u sh
w i t h l a r g e a m o u n t s o f w a t e r .
If contact with eyes is made, wash eyes
with water and get medical aid immediately.
(1) Clean all parts using cleaning solvent P-D-680; dry using clean cloths.
(2) Check engine hoods (17) and side supports (21) for cracks, breaks, dents,
or excessive corrosion. Remove corrosion using a stiff wire brush. Touch
up all bare metal areas using MIL-C-46168 paint, color forest green.
( 3 ) I n s p e c t r e m a i n i n g p a r t s f o r c r a c k s , b r e a k s , d i s t o r t i o n , d e f o r m a t i o n , a n d
damaged threads. Replace as necessary.
9-19
