TM 5-3805-262-34
INSTALLATION (SHEET 1 OF 2)
NOTE
Do not perform step (1) below unless replacement of molding (5) is
required.
(1) Position new bulk molding (5) in cab flange to determine proper length
required. Cut to proper length using knife.
(2) Lubricate molding (5) using detergent and water solution.
(3) Position molding (5) in cab flanges.
Wear protective goggles and heavy gloves when
installing glass. Remove
and handle broken glass carefully. Failure to do so could cause serious
injury due to glass puncturing or cutting your skin. If you are injured
by broken glass, obtain medical aid immediately.
(4) Position bottom of windshield (1) in molding (5) from outside of cab.
3-609
