TM 5-3805-290-23-1
TROUBLESHOOTING SYMPTOM INDEX - CONTINUED
0007 00
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
ENGINE ECM - CONTINUED
0007 00
Table 1. MID 036 - Engine Control - Continued.
TROUBLE-
CID
SHOOTING
FMI
FAULT
PROCEDURE
CODE
DESCRIPTION
FAULT CONDITIONS/EFFECTS
PAGE
0174 02
Fuel Temperature Sensor This code is generated when ECM detects a fuel temperature signal that
Data Erratic.
is erratic or intermittent. Both 174-02 and 342-02 diagnostic codes will
be active if fuel injection pump has suffered a complete failure of
electrical supply or if there has been a communication fault between
ECM and CAN data link for fuel injection pump. ECM will log
diagnostic code only if engine is running. When this code is generated,
engine may shut down or have low power.
0247 09
J1939 Data Link
This code is generated when ECM has detected a loss of
communications with J1939 data link. Machine may not have engine
speed control. ECM will generate a 247-09 diagnostic code on CAT
data link.
0262 03
5V Sensor dc Power
This code is generated when ECM reads signal voltage above normal
Supply Short to +Batt.
and ECM has been powered for at least three seconds. ECM will log
diagnostic code. While diagnostic code is active, engine may have low
power or misfire.
0262 04
5V Sensor dc Power
This code is generated when ECM reads a signal voltage below normal
Supply Short to Ground. and ECM has been powered for at least three seconds. ECM will log
diagnostic code. When this code is generated, engine may have low
power or misfire.
0007 00-8
