TM 5-3805-290-23-1
TROUBLESHOOTING WITHOUT A DIAGNOSTIC CODE - CONTINUED
0008 00
Table 2. Electrical System Troubleshooting - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
8. Check sensor output circuit to bucket/ 1. If continuity is present, replace kickout
17. One or More Kickouts Are
fork switch.
sensor (WP 0057 00).
Inoperative - Continued.
(a) Wiring harness remains
2. If continuity is not present, there is an
disconnected from kickout sensor.
open circuit between bucket/fork
(b) Wiring harness remains
switch and kickout sensor. Replace
disconnected from bucket/fork
wiring harness in question (WP 0169
switch.
00 thru WP 0175 00).
(c) Check continuity at kickout sensor
between wiring harness pin B,
circuit 762 (YL) and bucket/fork
switch wiring harness pin 1, circuit
762 (YL).
9. Check sensor output circuit.
1. If continuity is present, replace pilot
(a) Disconnect wiring harness from
valve (WP 0188 00).
pilot valve (WP 0188 00).
2. If continuity is not present, go to Test
(b) Wiring harness remains
10.
disconnected from kickout sensor.
(c) Turn battery disconnect switch
and engine start switch to OFF
position (TM 5-3805-290-10).
(d) Place bucket/fork switch in FORK
position (TM 5-3805-290-10).
(e) Check continuity at kickout sensor
between wiring harness pin B,
circuit 964 (BU), and pilot valve
wiring harness pin 3, circuit 963
(GN).
10. Check bucket/fork switch.
1. If continuity is present, there is an open
(a) Disconnect wiring harness from
circuit between pilot valve and bucket/
bucket/fork switch (WP 0049 00).
fork switch. Replace wiring harness in
(b) Place bucket/fork switch in FORK
question (WP 0169 00 thru WP 0175
position (TM 5-3805-290-10).
00).
(c) Check continuity of bucket/fork
2. If continuity is not present, replace
switch between pin 2 and pin 3.
bucket/fork switch (WP 0049 00).
0008 00-42