TM 5-3805-290-23-1
ELECTRICAL SYSTEM TESTS, INSPECTIONS, AND ADJUSTMENTS - CONTINUED
0013 00
ENGINE SPEED/TIMING SENSOR CIRCUIT TEST - CONTINUED
0013 00
f.
Expected Results. Electrical connectors and cables are properly installed.
(1)
If results are OK, electrical connectors and cables are properly installed. Proceed to step 3.
(2)
If results are NOT OK, complete these tasks when sensors are being installed:
(a) Lubricate O-ring with oil.
(b) Ensure sensor has connector face seal inside connector body. If seal is damaged or missing, replace
wiring harness in question (WP 0169 00 thru WP 0175 00).
(c) Ensure sensor is fully seated in engine before tightening bracket bolt (WP 0067 00).
(d) Ensure connector is latched on both sides.
(e) Ensure harness is properly secured and attached to harness clip.
(f) Verify repair has eliminated fault.
427-B0710
0013 00-41