TM 5-3805-290-23-1
HYDRAULIC SYSTEM TESTS, INSPECTIONS, AND ADJUSTMENTS - CONTINUED
0017 00
FAN SPEED CALIBRATION - CONTINUED
f.
Calibration procedure could be stopped for several reasons. Refer to Table 2 for error codes that can be displayed
by MSD. Correct condition that caused error code and restart calibration.
Table 2. Error Codes for Fan Speed Calibration.
ERROR
CODE
DESCRIPTION
PROCEDURE
0002
Active diagnostic present
There is active diagnostic code. Exit calibration and correct
condition that caused diagnostic code.
0006
Calibration aborted by tool/monitor
Calibration has been stopped by MSD. Restart calibration
procedure.
0009
Calibration aborted by ECM
Calibration has been stopped by ECM. Restart calibration
procedure.
1010
Engine stopped
Engine has stopped. Restart engine and set engine to high idle.
1012
Engine rpm incorrect
Engine rpm is not correct. Set engine rpm to high idle.
1018
Parking brake not engaged
Parking brake is not engaged. Set parking brake.
1020
Transmission gear incorrect
Transmission gear is not correct. Transmission must be in
NEUTRAL.
1048
Hydraulic oil temperature too low
Hydraulic oil temperature is too low. Repeat procedure to increase
hydraulic oil temperature.
1054
Hydraulic oil temperature too high
Hydraulic oil temperature is too high. Decrease engine speed and
ensure engine access doors are closed.
1074
Engine rpm too low
Engine rpm is too low. Set engine rpm to high idle.
0017 00-22