TM 5-3805-290-23-2
HYDRAULIC SYSTEM OIL CHANGE AND FILTER REPLACEMENT - CONTINUED
0137 00
FILTER INSTALLATION
1.
Apply a thin coat of oil to seal on new hydraulic system filter (5).
N OT E
There are rotation index marks on hydraulic system filter that are spaced 90 degrees, or 1/4 of a turn, away
from each other. When tightening filter, use rotation index marks as a guide. Tighten filter according to
instructions printed on filter.
Hydraulic system tank capacity approximately 18.5 gal. (70 L).
2.
Install new hydraulic system filter (5) on mounting base (6) hand-tight until seal contacts base. Note position of index
marks on filter in relation to a fixed point on mounting base.
3.
Install new hydraulic tank breather, if removed (WP 0140 00).
4.
Operate machine and check for correct operation (TM 5-3805-290-10).
5.
Shut down engine (TM 5-3805-290-10).
6.
Check for hydraulic oil leaks.
7.
Re-check hydraulic oil level (TM 5-3805-290-10).
8.
Close right-side engine access door (TM 5-3805-290-10).
END OF WORK PACKAGE
0137 00-5/(0137 00-6 Blank)
