TM 5-3805-290-23-2
AIR CONDITIONING/HEATER BLOWER MOTOR REPLACEMENT - CONTINUED
0143 00
INSTALLATION - CONTINUED
6.
Position cover (35) and install three screws (34).
Tighten to 10 1 lb-in. (1.2 0.2 Nm).
427-B0743
7.
Repeat steps 4 thru 6 for remaining blower wheel.
8.
Connect AC wiring harness (20) to cab harness (33).
9.
Install grommet (32) in case assembly (3).
10.
Install AC wiring harness (20) through grommet (32).
11.
Install AC wiring harness (20) on clip (30).
12.
Install two new tiedown straps (31) on AC wiring harness (20).
13.
Connect AC wiring harness (20) to thermostat switch (29).
14.
Position blower assembly (28) into case assembly (3).
15.
Install washer (27) and nut (26) on motor mount. Tighten nut to 70 24 lb-in. (8 3 Nm).
16.
Install washer (25) and bolt (24) on motor mount. Tighten bolt to 106 24 lb-in. (12 3 Nm).
17.
Connect AC wiring harness (20) to resistor (22).
427-B0742
0143 00-8