TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(b) Software part number for Messenger.
1. If all part numbers are correct, go to Test
0967 09 - Continued.
2.
2. If all part numbers are not correct, one
ECM may have wrong part number and/
or software configuration is not correct.
Appropriate flash file needs to be
flashed into ECM (WP 0056 00, WP
0057 00, WP 0060 00, and WP 0063 00).
2. Inspect wiring harness connections.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Disconnect and inspect wiring harness
connections related to CAT Data Link
(WP 0237 00). Make sure connectors
are clean and tight. Refer to Electrical
Connectors Inspection (WP 0022 00)
as necessary.
(c) Check mating of connector.
(d) Check wires at connector.
(e) Check each wire for nicks and/or signs
of abrasion in insulation.
(f) Check for moisture at connector.
(g) Check for dirty and/or corroded
contacts.
(h) Check each pin and socket.
(i) Reconnect all connectors.
1. If wiring harness connectors are tightly
connected and free of corrosion, go to
Test 3.
2. If wiring harness connectors require
repair, replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
3. Check for additional related diagnostic
codes.
(a) Ensure all ECMs that use CAT Data
Link are connected.
(b) Turn battery disconnect and engine
start switches to ON position (TM 5-
3805-291-10).
0009 00-100
