TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
6. Check for open circuit in wiring harness.
0967 02 - Continued.
(a) Engine start and battery disconnect
switches remain in OFF position (TM
5-3805-291-10).
(b) All related ECMs remain disconnected
from wiring harness.
(c) Check continuity of CAT Data Link
circuit in wiring harness.
(d) Perform the following measurements:
(1) Measure resistance from contact J1-
20 (wire 945-BR) of ECM to corre-
sponding connector contacts of all
other ECMs.
(2) Measure resistance from contact J1- 1. If resistance measures less than 5 Ohms,
CAT Data Link circuit is correct. Go to
10 (wire 944-OR) of ECM to corre-
Test 7.
sponding connector contacts of all
other ECMs.
2. If resistance measurement is greater
than 5 Ohms, CAT Data Link circuit is
open in wiring harness. Replace the
wiring harness in question (WP 0195 00
thru WP 0201 00).
7. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Use messenger to check status of CID
1. If CID 0967 FMI 02 is active, exit this
0967 FMI 02 (TM 5-3805-291-10).
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 0967 FMI 02 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
0009 00-98
