TM 5-3805-291-23-1
CHANGING ENGINE OIL AND FILTER - CONTINUED
0025 00
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
1.
Clean all parts and mating surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
3.
Inspect all parts for wear, pitting, cracks, or corrosion and replace if necessary.
INSTALLATION
1.
Apply a thin coat of clean oil to seal of new engine oil filter (2).
2.
Install new engine oil filter (2) hand tight until seal contacts filter mounting base (3).
3.
When new engine oil filter (2) seal contacts filter mounting base (3), hand tighten an additional 3/4 turn.
4.
Remove oil filler cap (4) on right side of engine.
5.
Fill engine crankcase with 9.25 gal. (35 L) of fresh oil.
6.
Clean oil filler cap (4) and install on machine.
7.
Run engine until normal operating temperature is
reached (TM 5-3805-291-10).
8.
Check for engine oil leaks.
9.
Shut down engine and wait at least 3 minutes (TM 5-
3805-291-10).
10.
Check engine oil level on dipstick (5). Adjust oil level
as necessary.
11.
Close hood (TM 5-3805-291-10).
427-C0102
END OF WORK PACKAGE
0025 00-3/(0025 00-4 Blank)