TM 5-3805-291-23-2
CRANKSHAFT SPEED/TIMING SENSOR (PRIMARY) REPLACEMENT - CONTINUED
0078 00
REMOVAL
1.
Remove nut (1) and washer (2) from oil pan stud (3).
2.
Remove connector (4) from clamp (5).
3.
Disconnect connector (4) from engine wiring harness (6).
4.
Remove bolt (7) and washer (8) from crankshaft speed/timing sensor (9).
5.
Remove crankshaft speed/timing sensor (9), wiring harness (10), and O-ring (11). Discard O-ring.
427-C0272
INSTALLATION
1.
Lubricate new O-ring (11) with a thin coat of clean oil. Install new O-ring in wiring harness (10) and then place crank-
shaft speed/timing sensor (9) in position.
2.
Install washer (8) and bolt (7) in crankshaft speed/timing sensor (9).
3.
Connect connector (4) to engine wiring harness (6).
4.
Install connector (4) on clamp (5).
5.
Install washer (2) and nut (1) on oil pan stud (3).
6.
Run engine until normal operating temperature is reached (TM 5-3805-291-10).
7.
Shut down engine (TM 5-3805-291-10).
8.
Check for oil leaks.
END OF WORK PACKAGE
0078 00-2