TM 5-3805-291-23-2
WHEEL AND TIRE ASSEMBLY (REAR) REPLACEMENT - CONTINUED
0120 00
INSTALLATION
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting equipment used is in good condition and of suitable load capacity. Keep
clear of heavy parts supported only by lifting equipment. Failure to follow this warning may result in injury
or death to personnel.
N OT E
Rim and tire weighs 1,500 lb (680 kg).
Tighten bolts in criss-cross pattern.
1.
With assistance, use lifting equipment to position tire and rim (3) on machine. Install 20 bolts (4) and washers (5) on rim
and tighten to 420 + 60 lb-ft (570 + 80 Nm). Tighten bolts an additional 60 + 5 degrees.
2.
Lower machine to ground.
3.
Remove block between rear axle housing (1) and
frame (2). Repeat for opposite side of machine.
427-C0195
4.
Install rear fender (WP 0137 00).
WAR N I N G
Before operating the machine, secure the steering frame lock in the stowed position. DO NOT operate
machine with steering frame lock connected. Failure to lock steering frame lock into the stowed position
before operating can result in loss of steering and injury or death to personnel.
5.
Secure steering frame lock in stowed position (TM 5-3805-291-10).
END OF WORK PACKAGE
0120 00-3/(0120 00-4 Blank)
