TM 5-3805-291-23-2
ENGINE OIL PAN MAINTENANCE - CONTINUED
0181 00
DISASSEMBLY
1.
Remove two bolts (25) and washers (24) from machine.
2.
Remove two bolts (21), washers (22), oil pickup tube (23), and O-ring (26) from machine. Discard O-ring.
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
1.
Remove all gasket material from mounting surfaces.
2.
Clean all parts and mating surfaces with solvent cleaning compound.
3.
Dry parts with compressed air.
4.
Inspect all parts for wear, pitting, cracks, or corrosion and replace if necessary.
ASSEMBLY
N OT E
Apply a thin coat of clean oil to all O-rings prior to installation.
1.
Install oil pickup tube (23), new O-ring (26), two washers (22), and bolts (21) on machine.
2.
Install two washers (24) and bolts (25) on machine.
0181 00-3
