TM 5-3805-291-23-2
TRANSMISSION HYDRAULIC CONTROL RELIEF VALVE REPLACEMENT - CONTINUED
0202 00
INSTALLATION
N OT E
Apply a thin coat of clean oil to all O-rings before installation.
1.
Install new O-ring (11) and torque converter inlet relief valve (10) on transmission (3).
2.
Install new O-ring (9), transmission hydraulic control relief valve (8), four washers (7), and bolts (6) on transmission
(3). Tighten bolts to 22 3 lb-ft (30 4 Nm).
3.
Install new O-ring (5) and connect hose assembly (4) to transmission (3).
4.
Install new O-ring (2) and connect hose assembly (1) to transmission (3).
5.
Install cab (WP 0132 00).
WAR N I N G
Before operating the machine, secure the steering frame lock in the stowed position. DO NOT operate
machine with steering frame lock connected. Failure to lock steering frame lock into the stowed position
before operating can result in loss of steering and injury or death to personnel.
6.
Secure steering frame lock in stowed position (TM 5-3805-291-10).
7.
Start machine (TM 5-3805-291-10).
8.
Run engine until operating temperature is reached and verify correct operation of machine (TM 5-3805-291-10).
9.
Shut down engine (TM 5-3805-291-10).
10.
Check oil level (TM 5-3805-291-10).
11.
Check for leaks.
END OF WORK PACKAGE
0202 00-3/(0202 00-4 Blank)