TM 5-3805-292-10
0005
PARKING MACHINE
0005
Stopping Machine
0005
1. Choose a level surface to stop machine whenever possible.
2. Release LH (ground drive) control lever to stop machine.
3. Lower work tool to the ground and apply light downward pressure. Refer to Operating Loader in this work
package.
4. If parking brake light is not illuminated, press parking brake button located on right-hand (RH) control lever
(WP 0004). Parking brake engages automatically when seat belt is released or when engine is turned off.
END OF TASK
Stopping Engine
0005
CAUTION
Stopping engine immediately after it has been operating under a load can result in
overheating and accelerated wear of engine components.
The following shutdown procedures allow engine to cool. This will prevent excessive
temperatures in turbocharger center housing. Failure to stop engine properly may cause
premature engine failure.
1. Run engine at idle (with throttle lever about one inch forward) for 5 minutes.
2. Turn off lights and accessories.
3. Push POWER button to stop machine.
4. Move auxiliary hydraulic pedal side to side to relieve hydraulic system pressure. See Relieving Hydraulic Sys-
tem Pressure in this work package.
END OF TASK
Leaving Machine
0005
1. Inspect cab interior for debris. Remove debris.
2. Release seat belt.
3. Using sliding glass lock levers, slide windows closed (WP 0004).
WARNING
Use caution and maintain three-point contact at all times when dismounting machine.
Failure to follow this warning may result in injury or death to personnel.
4. Exit cab and dismount machine using grab handles and step. Face machine when dismounting.
5. Close and lock door with door key. Install padlock on rear access door.
6. Perform After operation PMCS (WP 0020).
END OF TASK
0005-15
