2
TM 5-3805-292-10
OPERATOR MAINTENANCE
-
BUCKET REPLACEMENT
0015
INSTALLATION, REMOVAL
INITIAL SETUP
Tools and Special Tools
Personnel Required
0
0
Hammer (WP 0031, Table 2, Item 3)
Two
0
0
Pin Punch (WP 0031, Table 2, Item 4)
0
References
0
0
0
0
WARNING
DO NOT exceed lifting capacity of machine. M400W capacity is 1,980 lbs (900 kg).
M400T capacity is 2,100 lbs (953 kg).
Operate bucket only from operator's station.
When operating bucket on slopes, drive up and down, not across. Avoid steep hillside
operation.
Reduce speed of machine when driving over rough terrain, on a slope, or turning to avoid
overturning.
Before exiting machine, lower bucket to ground and shut off engine.
DO NOT heap load heavy material where the combined weight of the bucket and material
could exceed the rated lifting capacity of the machine.
Be sure load does not stick out too far in front of bucket. A light load sticking out too far
can have same tipping effect as a heavy load carried in close.
When using clam back blade, lift load slightly and make sure that load is secure. If load
appears to be unstable, lower load, open clam back blade, and reposition load to attain full
stability.
Failure to follow these warnings may result in injury or death to personnel or damage to
equipment.
0015-1
