TM 5-3805-298-23-1
0081
Table 1. 96 Fuel Level Sensor Diagnostic Codes - Continued.
081
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
4. Remove right lower cab access
96-3 Fuel Level Sensor
panels (WP 0347).
Voltage Is Above Normal or
Shorted High - Continued
5. Disconnect connector M-C1
(WP 0012, Figure 57) from
connector C-C20 (WP 0012,
Figure 56).
6. Using digital multimeter
Continuity - Replace rear frame wiring
(WP 0174), test for continuity
harness (WP 0295).
between connector M-C1
Proceed to Test Step 4.
(WP 0012, Figure 57) terminal 14
No Continuity - Proceed to Test Step 3.
and all other M-C1 terminals.
Test Step 3. Test for Shorted Lower
Cab Wiring Harness.
1. Remove left lower cab access
panels (WP 0347).
2. Remove transmission ECM cover
(WP 0266).
3. Disconnect connector C-C12
(WP 0012, Figure 26) from
Transmission ECM J1.
4. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C20
Proceed to Test Step 4.
(WP 0012, Figure 56) terminal 14
No Continuity - Proceed to step 5.
and all other C-C20 terminals.
5. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C12
Proceed to Test Step 4.
(WP 0012, Figure 26) terminal 22
No Continuity - Replace transmission
and all other C-C12 terminals.
ECM (WP 0266).
Proceed to Test Step 4.
Test Step 4. Verify Malfunction Is
Resolved.
1. Ensure all harness connectors are
connected.
2. Install oil cooler cover (WP 0340).
3. Install right lower cab access
panels (WP 0347).
4. Install transmission ECM cover
(WP 0266).
5. Install left lower cab access panels
(WP 0347).
0081-3