TM 5-3805-298-23-1
0081
Table 1. 96 Fuel Level Sensor Diagnostic Codes - Continued.
081
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Test for Faulty Fuel Level
96-4 Fuel Level Sensor
Sensor.
Voltage Is Below Normal or
1. Turn ignition switch and battery
Shorted Low - Continued
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove oil cooler cover for
access to connectors (WP 0340).
3. Disconnect connector M-C12
(WP 0012, Figure 58) from fuel
level sensor.
4. Turn ignition switch and battery
disconnect switch to ON position
(TM 5-3805-298-10).
5. Connect MSD. Select
Diagnostic Code 96-3 Fuel Level
Transmission 924H, and check for
Sensor Voltage Is Above Normal
Becomes Active - Replace fuel level
active diagnostic codes
gauge sensor (WP 0276).
Proceed to Test Step 5.
Diagnostic Code 96-4 Fuel Level
Sensor Voltage Is Below Normal
Remains Active - Proceed to Test
Step 3.
Test Step 3. Test for Shorted Rear
Frame Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove right lower cab access
panels (WP 0340).
3. Disconnect connector M-C1
(WP 0012, Figure 57) from
connector C-C20 (WP 0012,
Figure 56).
4. Using digital multimeter
Continuity - Replace rear frame wiring
(WP 0174), test for continuity
harness (WP 0295).
between connector M-C1
Proceed to Test Step 5.
(WP 0012, Figure 57) terminal 14
No Continuity - Proceed to step 5.
and terminal 23.
5. Using digital multimeter
Continuity - Replace rear frame wiring
(WP 0174), test for continuity
harness (WP 0295).
between connector M-C1
Proceed to Test Step 5.
(WP 0012, Figure 57) terminal 14
No Continuity - Proceed to Test Step 4.
and ground.
0081-5
