TM 5-3805-298-23-1
0085
Table 1. 262 Five-Volt Transmission Sensor Power Supply Diagnostic Codes - Continued.
085
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
4. Disconnect connector C-C19
262-3 Five-Volt Sensor
(WP 0012, Figure 23) from
Power Supply Voltage Is
connector EN-C8 (WP 0012,
Above Normal or the
Figure 22).
Voltage Is Shorted High -
Continued
5. Using digital multimeter
Continuity - Replace engine wiring
(WP 0174), test for continuity
harness (WP 0299).
between connector EN-C8
Proceed to Test Step 4.
(WP 0012, Figure 22) terminal 11
No Continuity - Proceed to Test Step 3.
and all other EN-C8 terminals.
Test Step 3. Test for Shorted Lower
Cab Wiring Harness.
1. Disconnect connector C-C7
(WP 0012, Figure 59) from
transmission neutralizer sensor.
2. Remove left lower cab access
panels (WP 0347).
3. Remove transmission ECM cover
(WP 0266).
4. Disconnect connector C-C12
(WP 0012, Figure 26) from
Transmission ECM J1.
5. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C12
Proceed to Test Step 4.
(WP 0012, Figure 26) terminal 11
No Continuity - Replace transmission
and all other C-C12 terminals.
ECM (WP 0266).
Proceed to Test Step 4.
Test Step 4. Verify Malfunction Is
Resolved.
1. Ensure all wiring harness
connectors are connected.
2. Install right lower cab access
panels (WP 0347).
3. Install transmission ECM cover
(WP 0266).
4. Install left lower cab access panels
(WP 0347).
5. Using MSD, check for active
262-3 Five-Volt Sensor Power Supply
diagnostic codes (WP 0008).
Voltage Is Above Normal Becomes
Inactive - Troubleshooting complete.
262-3 Five-Volt Sensor Power Supply
Voltage Is Above Normal Remains
Active - Repeat troubleshooting from
the beginning.
0085-3