TM 5-3805-298-23-1
0088
Table 1. 367 Ride Control Rocker Switch Diagnostic Codes - Continued.
088
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector C-C36
367-2 Ride Control Rocker
(WP 0012, Figure 63) from ride
Switch Data Is Erratic,
control switch (WP 0012,
Intermittent, or Incorrect -
Figure 64).
Continued
4. Push ride control switch to OFF
position (TM 5-3805-298-10).
5. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to step 6.
between ride control switch
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 64) terminal 4
Replace ride control switch (WP 0264).
and terminal 5.
Proceed to Test Step 6.
6. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Replace ride control switch (WP 0264).
between ride control switch
Proceed to Test Step 6.
(WP 0012, Figure 64) terminal 6
Resistance Greater Than 5.0 Ohms -
and terminal 5.
Proceed to step 7.
7. Push ride control switch to AUT
position (TM 5-3805-298-10).
8. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to step 9.
between ride control switch
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 64) terminal 6
Replace ride control switch (WP 0264).
and terminal 5.
Proceed to Test Step 6.
9. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Replace ride control switch (WP 0264).
between ride control switch
Proceed to Test Step 6.
(WP 0012, Figure 64) terminal 4
Resistance Greater Than 5.0 Ohms -
and terminal 5.
Proceed to Test Step 3.
Test Step 3. Test for Open Lower Cab
Wiring Harness.
1. Connect jumper wire between
terminal 4 and terminal 6 of
connector C-C36 (WP 0012,
Figure 63).
2. Remove left lower cab access
panels (WP 0347).
3. Remove transmission ECM cover
(WP 0266).
4. Disconnect connector C-C13
(WP 0012, Figure 25) from
Transmission ECM J2.
0088-3