• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Table 1. 367 Ride Control Rocker Switch Diagnostic Codes - Continued.
Table 1. 367 Ride Control Rocker Switch Diagnostic Codes - Continued.

Field Maintenance Manual For 924H Wheel Loader -1 Page Navigation
  953    954    955    956    957  958  959    960    961    962    963  
img
. . . . . . .
TM 5-3805-298-23-1
0088
Table 1. 367 Ride Control Rocker Switch Diagnostic Codes - Continued.
088
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using digital multimeter
367-2 Ride Control Rocker
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Switch Data Is Erratic,
Proceed to Test Step 4.
between connector C-C13
Intermittent, or Incorrect -
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 25) terminal 45
Continued
Replace lower cab wiring harness
and terminal 46.
(WP 0291).
Proceed to Test Step 6.
Test Step 4. Test for Open Lower Cab
Ground.
1. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to Test Step 5.
between connector C-C36
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 63) terminal 5
Proceed to step 2.
and ground.
2. Inspect ground connections
Dirty, Corroded, or Loose - Clean and
(WP 0012, Figure 45) terminal 1
tighten as necessary.
and terminal 2 for dirt, corrosion,
Proceed to step 3.
and tightness.
No Problem Found - Replace lower
cab wiring harness (WP 0291).
Proceed to Test Step 6.
3. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to Test Step 6.
between connector C-C36
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 63) terminal 5
Replace lower cab wiring harness
and ground.
(WP 0291).
Proceed to Test Step 6.
Test Step 5. Test for Shorted Lower
Cab Wiring Harness.
1. Disconnect jumper wire between
terminal 4 and terminal 6 of
connector C-C36 (WP 0012,
Figure 63).
2. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C13
Proceed to Test Step 6.
(WP 0012, Figure 25) terminal 45
No Continuity - Proceed to step 3.
and ground.
3. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C13
Proceed to Test Step 6.
(WP 0012, Figure 25) terminal 46
No Continuity - Replace transmission
and ground.
ECM (WP 0266).
Proceed to Test Step 6.
0088-4


Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved.