• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Table 1. 740 Differential Lock Solenoid Diagnostic Codes - Continued.
Table 1. 740 Differential Lock Solenoid Diagnostic Codes - Continued.

Field Maintenance Manual For 924H Wheel Loader -1 Page Navigation
  1086    1087    1088    1089    1090  1091  1092    1093    1094    1095    1096  
img
. . . .
TM 5-3805-298-23-1
0104
Table 1. 740 Differential Lock Solenoid Diagnostic Codes - Continued.
0104
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
4. Using MSD, check for active
Diagnostic Code 740-5 Differential
740-5 Differential Lock
diagnostic codes (WP 0008).
Lock Solenoid Current Below
Solenoid Current Below
Normal Becomes Inactive -
Normal - Continued
Troubleshooting complete.
Diagnostic Code 740-5 Differential
Lock Solenoid Current Below
Normal Remains Active - Repeat
troubleshooting from the beginning.
NOTE
740-6 Differential Lock
Solenoid Current Above
Always inspect wiring harness connectors that are involved in the circuit.
Normal
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure and
that all connections are in good condition. If a problem with the
connection is found, correct the problem and verify that this malfunction
or diagnostic code is active before performing this procedure.
Perform open or short-circuit test at each wiring harness connection to
identify the correct wiring harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission ECM detects a short circuit or high current condition in the
differential lock solenoid.
POSSIBLE CAUSE
Lower cab wiring harness shorted to ground.
Front frame wiring harness shorted to ground.
Differential lock solenoid faulty.
Test Step 1. Check for Active
Diagnostic Codes.
Connect MSD. Select Transmission
Diagnostic Code 740-6 Active -
924H and check for active diagnostic
Proceed to Test Step 2.
codes (WP 0008).
Diagnostic Code 740-6 Not Active -
Troubleshooting is complete.
Test Step 2. Test for Faulty
Differential Lock Solenoid.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector LE-C17
(WP 0012, Figure 88) from
differential lock solenoid.
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
0104-6


Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved.