TM 5-3805-298-23-1
0113
Table 1. 1404 Solenoid Valve 4 (Second Gear) Diagnostic Codes - Continued.
0113
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 4. Test Transmission
1404-5 Solenoid Valve 4
Wiring Harness for High Resistance
(Second Gear) Current
or Open.
Below Normal - Continued
1. Disconnect connector P-C1
(WP 0012, Figure 53) from
connector C-C15 (WP 0012,
Figure 52).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0174), measure resistance
Replace lower cab wiring harness
between connector P-C1
(WP 0291).
(WP 0012, Figure 53) terminal 17
Proceed to Test Step 5.
and terminal 12.
Resistance Greater Than 5.0 Ohms
Replace transmission wiring harness
(WP 0298).
Proceed to Test Step 5.
Test Step 5. Verify Malfunction Is
Resolved.
1. Ensure all wiring harness
connectors are connected.
2. Install transmission ECM cover
(WP 0266).
3. Install left and right lower cab
access panels (WP 0347).
4. Install right engine access panel
(WP 0348).
5. Apply and hold service brake, start
Diagnostic Code 1404-5 Solenoid
engine, and shift transmission into
Valve 4 (Second Gear) Current Below
second gear forward
Normal Becomes Inactive
(TM 5-3805-298-10). Using MSD,
Troubleshooting complete.
check for active diagnostic codes
Diagnostic Code 1404-5 Solenoid
Valve 4 (Second Gear) Current Below
Normal Remains Active Repeat
troubleshooting from the beginning.
0113-6