TM 5-3805-298-23-1
0113
Table 1. 1404 Solenoid Valve 4 (Second Gear) Diagnostic Codes - Continued.
0113
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
5. Apply and hold service brake, start
1404-3 Solenoid Valve 4
Diagnostic Code 1404-3 Solenoid
engine, and shift transmission into
(Second Gear) Voltage Is
Valve 4 (Second Gear) Voltage Is
second gear forward
Above Normal - Continued
Above Normal Becomes Inactive
(TM 5-3805-298-10). Using MSD,
Troubleshooting complete.
check for active diagnostic codes
Diagnostic Code 1404-3 Solenoid
Valve 4 (Second Gear) Voltage Is
Above Normal Remains Active
Repeat troubleshooting from the
beginning.
NOTE
1404-5 Solenoid Valve 4
(Second Gear) Current
Always inspect wiring harness connectors that are involved in the circuit.
Below Normal
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure and
that all connections are in good condition. If a problem with the
connection is found, correct the problem and verify that this malfunction
or diagnostic code is active before performing this procedure.
Perform open or short-circuit test at each wiring harness connection to
identify the correct wiring harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission ECM detects an open circuit or low current condition in the solenoid
valve 4 (second gear) circuit.
POSSIBLE CAUSE
Transmission wiring harness high resistance or open.
Lower cab wiring harness high resistance or open.
Solenoid valve 4 (second gear) faulty.
Transmission ECM.
Test Step 1. Check for Active
Diagnostic Codes.
Connect MSD (WP 0008), select
Diagnostic Code 1404-5 Active
Transmission 924H. Apply and hold
Proceed to Test Step 2.
service brake, start engine, and shift
Diagnostic Code 1404-5 Not Active
transmission into second gear forward
Troubleshooting is complete.
(TM 5-3805-298-10). Using MSD,
check for active diagnostic codes
Test Step 2. Test for Faulty Solenoid
Valve 4 (Second Gear).
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).