TM 5-3805-298-23-2
0135
Table 1. One or Both Rear Work Lights Do Not Operate - Continued.
0135
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. Using digital multimeter
One or Both Rear Work
Voltage 18 to 26 V Replace rear RH
(WP 0174), test for voltage
Lights Do Not Operate -
work light (WP 0271).
between connector FE-C3
Continued
Proceed to Test Step 21.
(WP 0012, Figure 187) terminal 1
Voltage Less Than 18 V Replace
and terminal 2 (ground).
work light wiring harness (WP 0300).
Proceed to Test Step 21.
Test Step 3. Test for Voltage at Rear
LH Work Light.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector FE-C2
(WP 0012, Figure 185) from Rear
LH work light (WP 0012,
Figure 186).
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
4. Using digital multimeter
Voltage 18 to 26 V Replace rear LH
(WP 0174), test for voltage
work light (WP 0271).
between connector FE-C2
Proceed to Test Step 21.
(WP 0012, Figure 185) terminal 1
Voltage Less Than 18 V Replace
and terminal 2 (ground).
work light wiring harness (WP 0300).
Proceed to Test Step 21.
Test Step 4. Test for Open Lamps
Fuse.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove lamps fuse from fuse
panel (TM 5-3805-298-10).
3. Using digital multimeter
Resistance 5.0 Ohms or Less Install
(WP 0174), measure resistance
lamps fuse (TM 5-3805-298-10) and
between terminals of lamps fuse.
proceed to Test Step 5.
Resistance Greater Than 5.0 Ohms
Replace lamps fuse (TM 5-3805-298-
10) and proceed to Test Step 15.
Test Step 5. Test for Faulty Work
Light Switch.
1. Remove military light switch panel
for access to wiring harness
connectors (WP 0257).
0135-3