TM 5-3805-298-23-2
0135
Table 1. One or Both Rear Work Lights Do Not Operate.
0135
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
One or Both Rear Work
Lights Do Not Operate
Always inspect wiring harness connectors that are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure and
that all connections are in good condition. If a problem with the
connection is found, correct the problem and verify that this malfunction
or diagnostic code is active before performing this procedure.
Perform open or short-circuit test at each wiring harness connection to
identify the correct wiring harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
Test Step 1. Test Operation of Rear
Work Lights.
1. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
2. Turn the military light switch to
Ser. Drive position (TM 5-3805-
298-10).
3. Turn the work light switch to II
position (TM 5-3805-298-10).
4. Observe operation of both rear
Rear LH Work Light Operates and
work lights (TM 5-3805-298-10).
Rear RH Work Light Does Not
Operate Proceed to Test Step 2.
Rear RH Work Light Operates and
Rear LH Work Light Does Not
Operate Proceed to Test Step 3.
Both Rear Work Lights Do Not
Operate Proceed to Test Step 4.
Test Step 2. Test for Voltage at Rear
RH Work Light.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector FE-C3
(WP 0012, Figure 187) from rear
RH work light (WP 0012,
Figure 188).
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
