TM 5-3805-298-23-2
0159
Table 1. Service Brakes Do Not Hold - Continued.
0159
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Brake Wear Tool Fits Between
Service Brakes Do Not Hold
2. While an assistant applies the
Reaction Plates Drain and refill axle
- Continued
brakes, insert brake wear gauge
between reaction plates (Figure 4,
oil in front and rear axle (WP 0321).
Item 1).
Proceed to Test Step 4.
Brake Wear Tool Does Not Fit
Between Reaction Plates Replace
rear axle (WP 0322).
Proceed to Test Step 4.
Figure 4. Axle Inspection Port.
0159
Test Step 4. Verify Malfunction Is
Resolved.
1. Turn battery disconnect switch ON
and start engine
(TM 5-3805-298-10).
2. Raise the work tool above the
ground (TM 5-3805-298-10).
3. Turn transmission neutralizer
switch to ON (TM 5-3805-298-10).
4. Warm the transmission oil to
normal operating temperature of
approximately 165F to 185F
(75C to 85C).
5. Warm the hydraulic oil to operating
temperature of 140F (60C)
(TM 5-3805-298-10).
6. Apply service brake and release
parking brake
(TM 5-3805-298-10).