DISASSEMBLY AND ASSEMBLY
Lower the temperature of bearing cup (34) and
install it in cage (35).
Put clean power train oil on O-ring seal (33)
and install it on cage (35).
Install original shims (36) and cage (35) on the
case as shown.
Use tool (B) and pry bar (25) to check bearing
end play. Add or remove shims to get a bearing
end play of 0.05 to 0.15 mm (.002 to .006 in.).
Install plate (37) on the cage as shown.
NOTE: Cover (39) is replaced with supplemen-
tal steering pump on some units.
Install gasket (38) and cover (39) on the cage
a) connection of transmission to transfer
gears (see DISASSEMBLE TRANSMIS-