TM 5-2420-231-23-2
0109
REMOVAL CONTINUED
3. Use seal remover tool to remove outer rear main oil seal (Figure 2, Item 1) from flywheel housing (Figure 2,
Item 2). Discard outer rear main oil seal.
Figure 2. Outer Rear Main Oil Seal.
0109
END OF TASK
CLEANING AND INSPECTION
0109
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0369).
END OF TASK
INSTALLATION
0109
1. Install crankshaft rear seal installer base (Figure 3, Item 4) and two capscrews (Figure 3, Item 3) on engine.
2. Apply a light coat of oil to crankshaft rear seal installer seal surface (Figure 3, Item 1).
NOTE
Install rear main oil seal as noted during removal.
3. Slide new rear main oil seal (Figure 3, Item 2) onto crankshaft rear seal installer base (Figure 3, Item 4) until
rear main oil seal contacts engine.