TM 5-3805-255-14
0032
INSTALLATION
00032
1. Install governor (Figure 1, Item 2), two bolts (Figure 1, Item 3), and nuts (Figure 1, Item 4) to frame.
2. Connect tube (Figure 1, Item 5) and line (Figure 1, Item 1) to governor (Figure 1, Item 2).
3. Close drain valves, start engine, and check air pressure (WP 0005).
4. If necessary, adjust governor pressure.
END OF TASK
ADJUSTMENT
00032
1. Start engine and build up air system pressure. Note pressure at which governor cuts out. This pressure range
should be 90 to 105 psi (620.5 to 724.0 kPa).
2. If cutout pressure is incorrect, remove governor cover, loosen locknut, and turn adjusting screw clockwise to
lower pressure, or counterclockwise to raise pressure.
3. When proper pressure is obtained, tighten locknut.
4. Install engine access panels (WP 0005).
END OF TASK
END OF WORK PACKAGE
0032-3/(4 blank)