TM 5-3805-255-14
0035
REMOVAL
00035
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure that any lifting equipment used is in good condition
and of suitable load capacity. Keep clear of heavy parts supported by lifting equipment.
Failure to follow this warning may result in death or injury to personnel.
1. Install suitable lifting device on muffler (Figure 1, Item 3).
2. Remove two bolts (Figure 1, Item 5), nuts (Figure 1, Item 6), and clamp (Figure 1, Item 4) from muffler
(Figure 1, Item 3).
3. Lift muffler (Figure 1, Item 3) off pipe (Figure 1, Item 7) and lower to ground. Remove lifting device.
4. Remove nut (Figure 1, Item 8), bolt (Figure 1, Item 2), washer (Figure 1, Item 9), and weather cap (Figure 1,
Item 1) from muffler (Figure 1, Item 3).
END OF TASK
INSTALLATION
00035
1. Install weather cap (Figure 1, Item 1), washer (Figure 1, Item 9), bolt (Figure 1, Item 2), and nut (Figure 1, Item
8) on muffler (Figure 1, Item 3).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure that any lifting equipment used is in good condition
and of suitable load capacity. Keep clear of heavy parts supported by lifting equipment.
Failure to follow this warning may result in death or injury to personnel.
2. Install suitable lifting device on muffler (Figure 1, Item 3).
3. Position muffler (Figure 1, Item 3) on pipe (Figure 1, Item 7).
4. Install clamp (Figure 1, Item 4), two bolts (Figure 1, Item 5), and nuts (Figure 1, Item 6) on muffler (Figure 1,
Item 3).
5. Remove lifting device from muffler (Figure 1, Item 3).
6. Turn battery disconnect switch to ON position and start engine (WP 0005).
7. Check for exhaust leaks at muffler.
8. Install engine access panels (WP 0005).
0035-2
