TM 5-3805-255-14
0033
ADJUSTMENT CONTINUED
00033
Hand Throttle
00033
NOTE
Adjust foot throttle linkage before adjusting hand throttle linkage.
1. Install cable fitting (Figure 9, Item 3) on cable (Figure 9, Item 2).
2. Install cable clamp (Figure 9, Item 4) on cable (Figure 9, Item 2).
3. Connect fitting (Figure 9, Item 3) to lever (Figure 9, Item 5).
4. Adjust to allow slight clearance between lever (Figure 9, Item 5) and bellcrank arm (Figure 9, Item 6).
5. Adjust hand throttle cable (Figure 9, Item 1) so fuel injection pump lever travels to low idle position with throttle
pushed in; with the throttle pulled all the way out, engine must maintain a minimum speed of 1200 RPM (no
load). The throttle should lock in position by turning handle one quarter turn.
6. Install cable fitting (Figure 9, Item 3) and new cotter pin (Figure 9, Item 7).
7. Install engine access panels (WP 0005).
Figure 9. Hand Throttle.
0033
END OF TASK
END OF WORK PACKAGE
0033-10
