TM 5-3805-255-14
0085
CUTTING EDGE INSTALLATION CONTINUED
00085
Spade Nose Cutting Edge Installation
00085
NOTE
The spade nose cutting edge installation procedure is similar to the general purpose
cutting edge procedure, except the spade nose has two cutting edges instead of one.
Refer to Figure 5 and General Purpose Cutting Edge Installation in this work package.
END OF TASK
BUCKET TEETH REMOVAL
00085
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure that any lifting equipment used is in good condition
and of suitable load capacity. Keep clear of heavy parts supported by lifting equipment.
Failure to follow this warning may result in death or injury to personnel.
NOTE
Bucket does not have to be removed from loader for teeth replacement. The following
steps explain removal of one tooth.
Type I teeth are used with edge P/N X311567.
Type II teeth are used with edge P/N 923885C1.
0085-6
