TM 5-3805-255-14
0085
CUTTING EDGE REMOVAL
00085
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure that any lifting equipment used is in good condition
and of suitable load capacity. Keep clear of heavy parts supported by lifting equipment.
Failure to follow this warning may result in death or injury to personnel.
NOTE
Type I teeth are used with edge P/N X311567.
Type II teeth are used with edge P/N 923885C1.
General Purpose Cutting Edge Removal
00085
NOTE
Replace cutting edge tip before it wears back to weld joining tip and its backing plate. Use
a carbon-graphite electrode to remove weld at rear of tip. Attach replacement tip to
backing plate using a dry, low-hydrogen E-7018 (AWS) electrode.
1. Remove bucket from loader (WP 0086). Position bucket (Figure 1, Item 1) so that cutting edge tip (Figure 1,
Item 2) is accessible.
2. Prior to removing worn cutting edge tip (Figure 1, Item 2), straighten any existing bow in cutting edge (Figure 1,
Item 3).
WARNING
Wear tinted protective goggles and insulated gloves when working with acetylene torch
and/or welders and heated parts. Failure to do so could cause blindness from flame of
torch or serious injury due to burns.
3. Tack weld a brace (Figure 1, Item 1) in center of bucket (Figure 1, Item 4) to hold cutting edge (Figure 1,
Item 3).
Figure 1. Cutting Edge Replacement.
0085
0085-2