REASSEMBLY OF IDLER SHAFT
REASSEMBLY OF OUTPUT SHAFT
Assembly of output shaft is optional. In the following
illustrations the threaded end of the output shaft is to
the rear and is flanged, with the mechanical discon-
nect to the front.
Figure 78
Press taper bearing, (large diameter of taper inward),
over threaded end of output shaft against shoulder on
Figure 76
shaft. Position small output shaft gear in transmission
Install idler shaft and rear bearing in transmission
case to the rear. Position large output shaft gear in
case. Block shaft on rear of case and drive bearing
transmission case to the front with longer offset of
gear hub toward front. Insert output shaft through
on front of shaft.
rear bore of case and through large and small output
gears. Figure 78 shows proper stack up of gears. Drive
front taper bearing, (large diameter of taper inward),
on output shaft until bearing shoulders against small
gear.
Figure 77
Install bearing retainer and retainer bolts.
Figure 79
bolts 35 to 45 ft. lbs. [4,8-6,2 m.kg).
Install rear bearing cup on output shaft.
-32-