Figure 87
Install output shaft companion flange, flange "O" ring,
washer and nut.
Figure 85
Tighten output shaft bearing cap bolts 35 to 45 ft. lbs.
torque. [4,8-6,2 m.kg].
Figure 88
lock gears with a soft bar and tighten flange nut 175
to 200 ft. lbs. torque [24,2-27,6 m.kg]
REASSEMBLY OF REVERSE & INPUT SHAFT
Figure 86
Add or remove shims from bearing cap to adjust pre-
load. When bearings are adjusted properly, it will take
Figure 89
6 to 8 inch pounds [0,07-0,09 m.kg] more torque to
Install reverse shaft into transmission and through
turn gear train with cap bolts torqued than when bolts
reverse gear (hub of gear toward rear of case).
were loose.
-34-