Figure 47
Apply a light coat of Permatex No. 2 on the outer
Figure 44
diameter of the tachometer drive oil seal. Press seal
Install retainer washer and nuts, tighten to specified
(lip of seal up) in turbine shaft bearing retainer. In-
torque.
stall new "O" ring on retainer, position retainer on
converter housing.
Figure 45
Install output companion flange, "O" ring, washer and
Figure 48
nut. Block output gears with a soft bar. Tighten flange
nut 200 to 250 ft. lbs. torque [27,7 - 34,5 m.kg].
Install retainer bolts and tighten to specified torque.
Figure 49
Figure 46
Position pump gear bearing retainer ring on pump
Position turbine shaft tachometer adaptor on shaft. In-
gear. Press pump gear bearing on gear hub and se-
stall bolts and tighten to specified torque. Lockwire
cure with retainer ring.
to prevent loosening.
-11-