TM 5-3805-258-24-2ENGINEFLYWHEELINSTALL FLYWHEEL HOUSING1157-12Tools NeededABFT120Lifting Bracket19S9060Engine Stand111.2.Clean the old gasket from the surfaces of thecylinder block and flywheel housing that makecontact with each other. Install a new gasket(1) on the cylinder block.Install two ½”-13 NC guide bolts (2) in thecylinder block as shown.NOTE: Be careful not to damage the crankshaft rearseal when flywheel housing (3) is installed.3. Fasten tool (A) and a hoist to flywheel housing(3) and install it on the cylinder block.4. Tighten the flywheel housing bolts in the se-quence as shown in illustration B8984X1.5. Cut the bottom of the gasket even with theflywheel housing and cylinder block. Put5H2471 Gasket Cement on the bottom of thegasket where the gasket makes contact with thegasket for the oil pan plate. Remove shims (4)from each side and tighten all of the oil panbolts. Install the bolts that hold the oil pan plateto the flywheel housing.end by:a) install torque converter oil coolerb) install flywheelc) install starting motorDISASSEMBLY AND ASSEMBLYHOUSING5-158
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
