ENGINE TM 5-3805-258-24-2 DISASSEMBLY AND ASSEMBLY CRANKSHAFT REAR SEAL AND WEAR SLEEVE REMOVE  CRANKSHAFT  REAR  SEAL AND WEAR SLEEVE 1161-11 Tools  Needed A B C 1P3075 Puller  Assembly 1 5P7409 Distorter 1 5P7313 Ring 1 start  by: a)  remove  flywheel NOTE: When a replacement of the rear seal is made, a  replacement  of  the  wear  sleeve  is  to  be  made  also. 1.  Remove  the  crankshaft  rear  seal  with  tool  (A). 2.  Install  tool  (C)  in  the  rear  seal  bore. 3.  Install  tool  (B)  between  tool  (C)  and  the  wear sleeve.  Turn  tool  (B)  until  the  edge  of  the  tool makes  a  flat  place  (crease)  in  the  wear  sleeve. Do  this  in  two  or  more  places  until  the  wear sleeve is loose. 4  Remove  tool  (C)  and  the  wear  sleeve  by  hand. INSTALL  CRANKSHAFT  REAR  SEAL AND WEAR SLEEVE 1161-12 Tools  Needed A 9S8871 Locator 1 9S8858 Nut 1 9S8890 Bolt 3 5P7298 Installer 1 1.  Install  the  crankshaft  rear  seal  and  wear  sleeve with  tooling  (A)  as  follows: a) b) c) d) e) Put locator (1) in position on the crankshaft and  install  the  three  bolts  that  hold  it  in place. Put  clean  engine  oil  on  the  seal  lip  of  seal (6)   and   on   the   outside   diameter   of   wear sleeve  (2). Install  seal  (6)  on  wear  sleeve  (2)  from  the end of the wear sleeve that has the bevel on the  outside  diameter.  Make  sure  the  lip  of the  seal  is  toward  the  inside  of  the  engine and  the  bevel  that  is  on  the  outside  dia- meter  of  the  wear  sleeve  is  toward  the  out- side  of  the  engine  when  installed. Use  6V1541  Quick  Cure  Primer  to  clean the  outside  diameter  of  the  crankshaft flange  (3)  and  the  inside  diameter  of  wear sleeve  (2). Put   9S3265   Retaining   Compound   on   the outside   diameter   of   crankshaft   flange   (3) and  the  inside  diameter  of  wear  sleeve  (2). NOTE:  Make  sure  the  lip  of  the  seal  is  toward  the inside of the engine and the outside diameter bevel of the  wear  sleeve  is  toward  the  outside  of  the  engine. f)  Put  wear  sleeve  (2)  with  seal  (6)  on  locator g) h) a) 5-159 (1).  Put  installer  (4)  on  locator  (1)  and install  nut  (5).  Put  lubrication  on  the  face of  the  washer  and  the  nut. Tighten  nut  (5)  until  installer  (4)  comes  in contact   with   locator   (1). Remove  tooling  (A)  and  check  the  wear sleeve  and  seal  for  correct  installation. end by: install  flywheel