TM 5-3805-258-24-2POWER TRAINDISASSEMBLY AND ASSEMBLYENGINE AND TRANSMISSION39. For Models 950BNS and 950BS:40.41.42.43.a) Connect bracket (39) to governor.b) Connect cable assembly (40) to governorcontrol lever.For Models 950BNSCE and 950BSCE:a)b)c)d)Install housing (46) and two screws.Turn governor shaft clockwise to offposition. Install lever (47) and bushingswith lever approximately 35° forwardof vertical.Connect cable assembly (48) using washerand screw.Install gasket, cover (49) and six screws.Connect wires (41) to the solenoid andwires (42) to the starter.Connect air lines (43) and (44) to the engineas shown.Connect engine disconnect switch (45) tothe frame.end by:a) install hood*b) install muffler*WARNINGIf NBC exposure is suspected, all air filter mediashould be handled by personnel wearing pro-tective equipment. Consult your unit NBC Offi-cer or NBC NCO for appropriate handling or dis-posal instructions.c) install air cleaner housing*d) install radiator and guard*e) remove rear drive shaftf) remove center drive shaft*This operation is in the ENGINE DISASSEM-BLY AND ASSEMBLY section.Models 950BNS and 950BSModels 950 BNSCE and 950BSCE5-234
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business