POWER TRAIN
TM 5-3805-258-24-2
DISASSEMBLY AND ASSEMBLY
TORQUE CONVERTER
CONNECTION OF TORQUE CONVERTER
TO TRANSMISSION
3100-29
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Fasten two 3/8’’-l6 NC forged eyebolts (2)
and a hoist to torque converter (1) as shown.
Make sure O-ring seal (3) is installed around
the transmission case and put clean oil on it.
Lower torque converter (1) on to the transmis-
sion. Make sure dowels (4) on the transmission
are in alignment with the holes in the torque
converter.
Install O-ring seals (5) on transmission oil
pump (6) and put clean oil on them.
Install transmission oil pump (6) on the torque
converter.
Install O-ring seals (7) on outlet relief valve (8)
and put clean oil on them.
Install outlet relief valve (8) on the torque con-
verter.
Install the O-ring seals on both ends of tube
assembly (9) and put clean oil on them.
Install tube assembly (9) on the transmission
oil pump and the transfer gear case.
Fasten a hoist to hydraulic pump (10) as
shown.
Put the O-ring seal in position on the hydraulic
pump and put clean oil on it.
Install hydraulic pump (10) on the transmis-
sion oil pump.
end by:
a) install torque converter, transmission and
transfer gears
5-237
