TM 5-3805-258-24-2
POWER TRAIN
DISASSEMBLY AND ASSEMBLY
TRANSMISSION
5. Install ring (7) in the No, 1 clutch housing to
hold the shaft and bearing in place.
6. Install gear (8) on the end of the shaft as shown.
7. Install retainer (9) and bolt (10). Tighten the
bolt to a torque of 110 ± 10 N•m (80 ± 7
lb.ft.).
8. Install ring (11) on shaft (4).
9. Install rings (12) and (14) on piston ( 13). Make
sure the lips of the rings are as shown on the
piston.
10. Install piston (13) in the No. 1 clutch housing.
Make sure that the lips of the seals are down.
5-280
