TM 5-3805-258-24-2
POWER TRAIN
DISASSEMBLY AND ASSEMBLY
TRANSMISSION
43. Install two of tooling (B) and a hoist on No. 2
clutch housing (57). Install the clutch housing
on the plate as shown. The weight of the hous-
ing is 23 kg (50 lb.).
44. Install bolts (60) that hold the two housings
and plate together. Tighten the bolts to a torque
of 110 ± 10 N-m (80 ± 7 lb. ft.).
45. Lower the temperature of the two bearings and
put them in position in both ends of shaft (61).
Use tooling (D) to install the bearings until
they are 12.0 ± 0.5 (.472 ± .020 in.)from the
end of the shaft. The inside diameter of the
bearings must be 34.988 ± .039 mm (1.3775
± .0015 in.)after assembly.
46. Heat bearing (62) to a maximum temperature
of 135°C (275° F) and install it on the shaft as
shown. Make sure ball (63) in the shaft fits into
the notch in the bearing and the opening (slot)
in the bearing is toward the top of the shaft.
5-286
